THOMSON 114SOFTCTLX36 Shaft Carbon Steel 1.250 In D 36 In Measuring Equipment ADAMS RITE 451045000000 D1068 Deadlatch

ADAMS RITE 451045000000 D1068 Deadlatch Hand LH or RHR Steel Satin Aluminum Finish Backset 1 1/2 in Front Size 1 x 6 7/8 in Strike Length 4

5 ft Number of Steps 6 Assembled Load Capacity 450 lb Step Tread Expanded Metal Platform Depth 30 in Platform Width 30 in Bottom Width 32 in Base Depth 66 in Overall Width 32 in Climbing Angle 59 Degrees Step Depth 7 in Step Width 30 in Ladder Actuation Foot Activated Step Lock Finish Powder Coated colour grey Standards ANSI OSHA Compliant Rear Exit No

HONEYWELL 76074B0000060001 Pressure Switch Differential 51 to 90 psi Range 51 to 90 psi Port Type 1/8-27 in MNPT Contact Form 1NO/1NC NEMA Rating Not Rated Actuation Type Diaphragm Action Standard Series 5000 Factory On/Off Setting 60 psi AC Contact Rating 0

IRWIN 87910 Spade Drill Bit 5/8 in Drill Bit Size Hex Carbon Steel Shank Diametre 1/4 in Shank Hex Size 1/4 in Overall Length 4 3/4 in Bright (Uncoated)

BURNDY BIT350 Insulated Multitap Connector Body Material Aluminum colour Clear Finish Unplated For Conductor Material Aluminum Copper For Stranded Copper Wire Size - Minimum 10 AWG For Stranded Copper Wire Size - Maximum 350 kcmil Head Style Hex Hex Size 5/16 in Insulation Material Plastisol Maximum Operating Temperature 194 Degrees F Maximum Voltage 600 V Mounting Hole Size Not Applicable Number of Ports 2 RoHS Compliant Yes Standards CSA Approved UL 486A UL 486B UL Listed

THOMSON 114SOFTCTLX36 Shaft Carbon Steel 1.250 In D 36 In Measuring Equipment ADAMS RITE 451045000000 D1068 DeadlatchTHOMSON 114SOFTCTLX36 Linear Shaft System of Measurement Inch Diametre 1 1 4 in Shaft Type Non Hardened Solid Shaft End Type Plain Ends Core Type Solid Overall Length 36 in Surface Hardness Minimum Not Applicable Material Steel End Thread Size Not Applicable Mounting Hole Thread Size Not Applicable Diametre Tolerance Minimum 1. 246 in Diametre Tolerance Maximum 1. 25 in Mounting Hole centre to centre Not Applicable Mounting Hole centre to Shaft End